Traction control turned off, reduced engine power, and i was doing 75 on the hwy. It's very unsafe for this to happen. The mechanic picked it up today and replaced the throttle. I've never seen the engine go into power reduced mode because of a wheel sensor. Not saying it can't happen, but i think you have something else going on.
Our 2013 traverse recently began to give us a p2138 code while telling us the traction control was now off and giving the reduced engine power. All the reading i have. If you’re a proud owner of a 2014 chevy traverse, you may have encountered the daunting traction control off warning accompanied by a notice of engine power reduced. When it's cold out and you're pulling air in through a reduced pressure (i. e. , sucking it in), you can get moisture in the air freezing. This is why old carbureted engines had a means. When the traction control system detects a loss of grip, it automatically intervenes by adjusting engine power and applying brakes to the wheels that are slipping. Since last month every now and then the traction control turns off and service stabiltrak comes on and engine power is reduced to 25mph. I switched out the throttle body. When the traction control system determines that wheel slippage is occurring, it will automatically reduce engine power to the affected wheels. This is done by cutting fuel flow. The messages on mine showed up as service battery charging station soon. Then i got messages about stabiltrak and traction control. Then reduced power mode was. 2014 traverse with 36k miles, car stopped and engine power is reduced, service traction control service stabilitrak error messages displayed. Technician is saying pins in.
The messages on mine showed up as service battery charging station soon. Then i got messages about stabiltrak and traction control. Then reduced power mode was. 2014 traverse with 36k miles, car stopped and engine power is reduced, service traction control service stabilitrak error messages displayed. Technician is saying pins in. I have a 2012 traverse lt with 27,000km. Today when i got home here is what happened: Check engine light, traction control message, engine power reduced message and. Shut off and idle 3 minutes again (this was suggested through another forum and i. We haven't had an issue at all until last month when it threw an engine power reduction and stabilitrak and traction off fault (p1516, p2135, and p0121). See my thread in this specific forum (2011 chevy traverse ls error code p2176). Since january i had the stabilitrak issue. It was came with traction control turned off and. I have a 2010 chevy traverse lt with 48000 miles. Last week while driving my kids to school the traction control off, service stabilitrac, service traction control message appeared on. Check if your catalysts is blocked, because i have a similar issue with chevy and when the catalyst is replaced every thing bec ok. One thing i have found is wheel speed.
Today when i got home here is what happened: Check engine light, traction control message, engine power reduced message and. Shut off and idle 3 minutes again (this was suggested through another forum and i. We haven't had an issue at all until last month when it threw an engine power reduction and stabilitrak and traction off fault (p1516, p2135, and p0121). See my thread in this specific forum (2011 chevy traverse ls error code p2176). Since january i had the stabilitrak issue. It was came with traction control turned off and. I have a 2010 chevy traverse lt with 48000 miles. Last week while driving my kids to school the traction control off, service stabilitrac, service traction control message appeared on. Check if your catalysts is blocked, because i have a similar issue with chevy and when the catalyst is replaced every thing bec ok. One thing i have found is wheel speed.
