Tritium xray3 day/night sights, three dot. Some of the most common sig. I know the trick to address the takedown lever for assembly. I am having troubles with it during disassembly now. I have the slide locked to the rear, and then i can turn the.
I removed my fcu, reinstalled and now my takedown lever won’t move past the 3’oclock position so i can remove the slide… haven’t tried firing but everything else seems to. You need to take out the bar that’s connected to the takedown lever and then readjust the lever and reinsert the bar. You’ll notice once that left side of the bar is out the sear will push down. Your takedown lever bar is probably out of sync and is in the wrong position at the rear near the sear. Go online and you can find a youtube video to help you reset it. So now i'm trying to put the spring on, but a new issue has risen. I cannot move the takedown lever town to remove the slide. It gets to about 4 o'clock and is stuck. The mag is out and the slide is locked back but the damn takedown lever will not go to 6 o'clock position no matter how hard i force it. My thumb is bleeding at this point lol. Might not be the. It is now stuck at 7/5 o'clock. The slide sits about 1/8 from the back end of the frame, but racks ok and can be locked back with the release/catch. Also, can't get the slide off. You pull slide back and lock it open, with middle lever.
Might not be the. It is now stuck at 7/5 o'clock. The slide sits about 1/8 from the back end of the frame, but racks ok and can be locked back with the release/catch. Also, can't get the slide off. You pull slide back and lock it open, with middle lever. Then rotate front lever to 6 or beyond 6. Then manually release slide and it. It's possible the hole takedown lever goes in is off. Or the takedown lever itself may be slightly undersized. Curiously the finish on that part is very different. Almost purplish in color. As the title states my p365 xl has a dead trigger and a stuck takedown lever. I was at the range and made it through about 5 rounds before the trigger went dead. The gun was unfired before. Brand new p365, expected a slightly stiff take down lever upon first disassembly, right there at the ffl's counter. I dropped out the magazine, racked the slide back to show an. Just bought it, was trying to reassemble while getting familiarized with breakdown procedure and the dang takedown lever won’t move down. Can’t get the slide to disengage. While hold the slide back at this position, with my right thumb over the take down lever, i started working the lever back and forth about 10 times. You should feel the tension on. The takedown lever is stuck as well in the 5 o'clock position.
Then manually release slide and it. It's possible the hole takedown lever goes in is off. Or the takedown lever itself may be slightly undersized. Curiously the finish on that part is very different. Almost purplish in color. As the title states my p365 xl has a dead trigger and a stuck takedown lever. I was at the range and made it through about 5 rounds before the trigger went dead. The gun was unfired before. Brand new p365, expected a slightly stiff take down lever upon first disassembly, right there at the ffl's counter. I dropped out the magazine, racked the slide back to show an. Just bought it, was trying to reassemble while getting familiarized with breakdown procedure and the dang takedown lever won’t move down. Can’t get the slide to disengage. While hold the slide back at this position, with my right thumb over the take down lever, i started working the lever back and forth about 10 times. You should feel the tension on. The takedown lever is stuck as well in the 5 o'clock position. I was under the impression that if that was not in the 6 oclock position, it would not allow the slide to go. I go over the mechanics.
